Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: amnon on February 20, 2015, 02:36:14 PM

Title: SetToolParam()
Post by: amnon on February 20, 2015, 02:36:14 PM

Hej,

How can I set Tool 1 Length to 200 using function SetToolParam()

Best Regards
Amnon

Title: Re: SetToolParam()
Post by: Hood on February 20, 2015, 03:54:49 PM

SetToolParam(1,2,200)

That would set tool 1's Z offset to 200.

You can also do it via G Code or even use G Code in a VB button.
I use that method with my tool setter which is linked into Mach via a linear scale.

Hood

Title: Re: SetToolParam()
Post by: amnon on February 21, 2015, 02:12:15 PM

Thanks, works.

Amnon