Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Gerry Sweetland on February 07, 2015, 11:27:37 AM
-
Hello,
Sorry if this has been covered. Tried to search but I'm finding mostly info on mill setups and I want to make sure I understand it for my lathe.
I have image showing how I think the switches should be wired with the C10 BOB. I also have a screen cap of the ports and pins dialog.
I'm not sure about what to put in the boxes under the columns for port# and pin#.
Can some one take a look and let me know if I am on the right track?
In addition, can I use the E-Stop on my G0602 lathe has an E-Stop for both the lathe spindle and the stepper motors by adding the wires to the C10?
Thanks,
Gerry
(http://i669.photobucket.com/albums/vv55/lotus23bsr/Public%20Album/Limit%20and%20Home%20Switch%20Schematic_zpsc4br1ijo.jpg)
(http://i669.photobucket.com/albums/vv55/lotus23bsr/Public%20Album/Capture_zpsif8s2qjn.jpg)
-
You would enter Port as 1, assuming of course you are not using a secondary port.
Not sure about the E-Stop, it depends how many poles it has and whether they are already used.
Hood
-
Thanks Hood
Gerry