Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: quinchat on January 25, 2015, 04:11:56 PM
-
After the mill was turned off overnight, the next day the velocity setting for X axis was found to be 45 ipm rather than the long standing setting of 200 ipm. Changed the setting back to 200 ipm and it works OK.
I am running Mach3 version3.043.057 on a Dell Optiplex 745 computer with a XP operating system. Power management and screen saver are disabled.
Can anyone shed any light on the root cause?
Quin
-
Only thing I can think of is if the 200IPM takes your kernel over 25KHz and for some reason the Kernel got set to 25KHz.
Hood