Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: giordano on April 05, 2007, 07:12:11 PM
-
Wrong working with Mach3.
Hello to all. As it is looked at frm the images, the circuit made with Mach3 is not correct and with greater circuits the errors increase. I enclose also the working file. Thanks in advance. Giordano
-
It looks to me like you have lost steps... try sherline mode and see if you have the same problem
Thanks
Brian
-
Hi Brian. The strange thing is that some holes are to the center and others no. The axle are planned to 10 mm / s and the acceleration to 50 mm / sec*sec. The motors are planned to 800 step for turn. Thanks. Giordano
-
Also after you are done the run move back to X0.0 Y0.0 and see if you are on position
-
Hi, Giordano
Your F speeds are set to F300, Have you try-ed slowing it down.
When you setup Mach3 your Max Velocity and acceleration settings are based on F100, I think, I May be wrong about that ?.
Is your Mach Job finishing faster than the other. ?
All the holes seem to be in the center on Pre-cut view. ?
Just some Thought's Hear, Chip
-
Hi. In the preview the holes are to the center. I will try to reduce the speed.
The format of export of the post processor is important?
This line in the format 0.00: N4s G00 X14.84 Y14.71
The same line in the format 0.0000: N4 G00 X14.8361 Y14.7066. Thanks. Giordano