Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: comet on December 24, 2014, 07:11:43 AM
-
Hi,
im having an issue with the gecko 320x motor and supply connector, after a number of hours use mainly with the larger z motor the pin connector fails, ive heard of people soldering directly to the pins but im not so keen on that idea. has anybody out there found a solution?
regards Tony
-
Contact Gecko and discuss the problem... they are good to deal with.
-
its ok i just used the brass terminal connectors out of a small choc block (terminal strip) then super glued them together with plastic insulators between each other cut from an old credit card, works a treat !!