Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Hobie on December 20, 2014, 05:49:36 PM
-
I updated the driver for the USB Smooth Stepper and now when I attempt to launch M3 it hangs at the screen splash. I backed out the driver but I'm still stuck at the start. Any ideas short of re-installing M3 all over again?
TIA,
Ken
-
What ver of Windows? Is this the only program that won't launch? Sounds like a corrupt USB driver or a conflict issue. Even uninstalling bad drivers sometimes won't fix the problem. If you created a restore point before updating the driver (which should always be done) you could roll back to a previous date and see if that corrects it.
-
Win 7 and I did roll back the driver. M3 is the only app that will not run.