Machsupport Forum

Third party software and hardware support forums. => Newfangled Mill Wizard => Topic started by: OCB on December 14, 2014, 10:12:20 AM

Title: MillWizard Exit
Post by: OCB on December 14, 2014, 10:12:20 AM

I have a strange problem. I down loaded and installed Mill Wizard a few days ago and played around with it and no problems. Last night I purchased a License and installed as
per the instructions no problems. When I was ready to exit Mill Wizard it would not close?? I tried to close it with Task Manger and still it would not close. So after a little break I when back to the
shop and was going to work on another project when I opened the new project Mill Wizard close as if I just told it to exit???
So I opened Mill Wizard again and the same, the only way I can exit is after clicking exit and confirming I want to exit, is to try and load another project????
Thanks for any help on this problem.

Title: Re: MillWizard Exit
Post by: OCB on December 14, 2014, 06:48:09 PM

Re-installed Mill Wizard all is good now.