Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: wbrent7766 on December 13, 2014, 06:36:13 PM
-
G-code through Sheetcam. Problem is that as soon as it scrolls to the M05 code (early) the torch goes out, the machine finishes the movment and then goes on. Anybody have this issue?
-
Here is a pic of my machine before the torch was added. Scatch built 54" X 54"
-
Attach your xml and the code and maybe the issue can be found.
Hood
-
let's try this