Machsupport Forum
Third party software and hardware support forums. => Newfangled Mill Wizard => Topic started by: Analias on December 09, 2014, 11:13:29 PM
-
Mill Wizard 1.0.17 [licensed]
I have a job that uses the Keyway Slot operation. The generated g-code only specifies the feed speed (F) when plunging and does not override the feed when executing horizontal moves.
-Freeman
-
I think I already fixed that in the version Im working on now, but I will check. I am getting close to anew version that is going to have polygons and polylines, including full pocketing. Its very nice, but I have a couple interface issues we dont like to fix. Maybe out in a week or two.