Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: c30232 on December 06, 2014, 07:49:32 PM
-
I am seeking suggestions regarding external control buttons. That is, an interface that will allow the use of an industrial type button/joystick to trigger Mach hotkeys or macros. I have located a few posts on the topic, but they seem to be more of how to configure dated systems rather than recommendations on new installs.
Thanks!!!
-
If industrial it will likely be 24v so the options are not so good for addons as opposed to complete controller.
If however you can convert it to 5v then possibly a PoKeys would be a good option.
Hood
-
Thanks, is PoKeys current stuff? I have seen it and it seems suitable, however, I have not found a source on the web. What I do find is discontinued. Do you have an opinion regarding P.I. Engineering?
http://xkeys.com/xkeys/xkswi.php
http://xkeys.com/accessories/IndustrialFootSwitches.php
-
PoLabs still seem to be on the go, you will find them here http://poscope.com/
Think also CNC4PC may deal in their stuff if you are in the USA.
Not had any experience with the x keys I am afraid.
Hood
-
Thank you! That is a site I did not see. I must have been asleep at the switch.
-
Their PoBlocks programming software for the PoKeys looks like it would be excellent , I have never used it as I moved on from the PoKeys before it became available.
Hood