Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: lfjill on December 03, 2014, 07:55:41 PM

Title: card recognition
Post by: lfjill on December 03, 2014, 07:55:41 PM

Mach3 doesn't ask me at startup (as before did) for the card installed
I went to Function Cfg's - reset card option in menu and it shows in a window: Next time startup the program will ask you...
Nevertheless it doesn't ask and the card is not recognized.
How can I solve this without reinstalling?  I had motors and card configurated and tested and I don't want to begin again,

Is there a way it doesn't ask and it works with the card?
(xulifeng 250)

Thank you
L J

Title: Re: card recognition
Post by: Hood on December 04, 2014, 01:57:36 PM

Sounds like you may not have the plugin installed.
Hood

Title: Re: card recognition
Post by: lfjill on December 05, 2014, 01:20:17 PM

Hood

I verified the plugins folder to get the surprise that it was blank.  Then remembered that sometime I recovered the machine to a previous point respect the instalation of it some weeks ago.   

I installed it and it seem not to have any problem.

Thank you very much. 
Luis J

Title: Re: card recognition
Post by: lfjill on December 05, 2014, 01:21:38 PM

Is it a way to avoid being choosing the card each time the program starts and that it continue working well?

Title: Re: card recognition
Post by: Hood on December 06, 2014, 07:17:02 AM

You can choose the box on the page that you click, it says something like Do not ask me again.

Hood