Machsupport Forum

Third party software and hardware support forums. => CS-Lab => Topic started by: Alan XR8 on November 30, 2014, 03:36:03 PM

Title: Mach 4 beta plugin is out
Post by: Alan XR8 on November 30, 2014, 03:36:03 PM

Just found a beta plugin on CS-Labs site.
Installed it and had all my servos and spindle running in an hour. Seems ok. Will try and get my limits all setup later on and do some cutting.


Alan

Title: Re: Mach 4 beta plugin is out
Post by: dude1 on November 30, 2014, 08:19:25 PM

good stuff, hope it is nice and smoothie like darwin