Machsupport Forum
Mach Discussion => Video P*r*o*b*i*n*g => Topic started by: rscr1991 on November 18, 2014, 03:38:23 AM
-
Good Morning.
I did a Touch Probe by contact, to scan the face of rims and then polish the rim.
what happens is that for example the touch probe to pin down a zero and starts scanning each time it finds a point around az = 0 for example.
My question is, instead of z always return to zero point z there is some form of backtrack eg 5mm at each point q lies without having to backtrack when az = 0.? Thank you