Machsupport Forum
Third party software and hardware support forums. => PoKeys => Topic started by: progress on November 12, 2014, 08:55:12 AM
-
Hello,
I've used an encoder to change the Feed Override value and a button to reset it to 100%
But now I can set OVR to 500% and over and set it to negative values like -100%
When it goes in negative feed nothing happens because the mill is still in hold position but it's not much nice to see.
How i can tell at Pokeys plugin or at Mach3 that the minumum FOVR is 0%?
May I use a brain to do it or there is a specific setting?
-
+1 as I have same problem.
Did you notice that the FOVR above 300% dosen't change the actual feed ? (So above 300% nothing happens, just like below 0%)
-
This will be fixed in the plugin in next release.
-
great! I hope you will go ahead to improve the plugin for Mach3, and not only for Mach4!!
-
hello,
I have upgrade the plugin and the firmware v3.1.42 , but the problem still present.
When i turn down the encoder to decrease feed override, it go down under zero in negative value.....