Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: greg2fs on October 18, 2014, 02:10:59 PM
-
Hello, I'm using solidcam for 3 axis milling but there's no mach3 post processor for 4 axis. THen which program can I use ?
Thanks
-
greg2fs
I am currently looking at CamBam, it claims to be able to control the 4th axis, but I have yet to test this claim. I just have a slight issue (most probably operator fault, by default) in that I cannot get the G-code produced in CamBam to load to Mach even with M<ach set as the post processor in CamBam.
It also seems very affordable (think it's 149$) as opposed to cam's like BobcadCam, way over my entire years earnings, so I could never afford that.
-
DeskProto does 4th axis work well. Hobby license is about $350.
-
I use either Vcarve Pro or Aspire for my 4th axis work.
They are both Vectric programs.
http://www.vectric.com/index.html