Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: CCSINC on October 17, 2014, 06:01:27 AM
-
I need to add more inputs for limit switches. Mach 3, warp9 ss, windows xp, LAPTOP. I used the warp9 pinout addresses (port 3, pin 1-3, etc) in port and pins but I do not get any signal on the diagnostics page when operating the limit switch. Does mach 3 recognize port 3 or am I supposed to check something somewhere in mach 3 so it does.? Whats the difference between single ended and differential inputs?
-
Mach will recognise Port3 no problem, possibly there is a setting in the plugin to configure pins 1-9 as inputs rather than outputs?
Hood