Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: widpyro on October 16, 2014, 08:39:32 AM

Title: Help setting up homing switches
Post by: widpyro on October 16, 2014, 08:39:32 AM

I have questions about setting up limit homing switches:

1) were should I connect the other leg of the switch circuit to the signal ground? This works on my e-stop

2) how does one start the homing without running code. Do I enable my limit and homing switches by selecting x++, y++, etc

Please tell me how to set up my homing
Thank you
Jim

Title: Re: Help setting up homing switches
Post by: widpyro on October 16, 2014, 10:06:38 PM

Never mind, I figured it out.
Regards,
Jim