Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Jmorris on October 04, 2014, 03:58:00 PM

Title: Mastercam post processor for mach3
Post by: Jmorris on October 04, 2014, 03:58:00 PM
I am running Mastercam 9.0  and using the MPFAN.pst the table display in mach3 looks correct but the program does not run.

Same program posted using MasterCam_MACH3B.pst the table display is nothing like the subject drafted in Mastercam.  I also tried one other .pst _MACH3LA.pst and it only generates 3 lines of code.

What are others using with success or can you think of something I am doing wrong?
Title: Re: Mastercam post processor for mach3
Post by: ostie01 on October 07, 2014, 03:06:47 AM
Any Fanuc post should do it

Jeff