Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: johndolecki on October 02, 2014, 10:58:42 PM

Title: Powertron dc servo whats the lowest voltage they will run at?
Post by: johndolecki on October 02, 2014, 10:58:42 PM

Whats the lowest dc voltage will my stock Bridgeport DC servos will run at and still give reasonable performance?

I thinking of purchasing the CNCdrive DC servo drive but they offer 2 types a  low voltage and a higher voltage one

So the power supply selection would depend on what derive i get.

thanks john