Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: silverpuma on September 24, 2014, 04:27:38 AM
-
Hallo
Gage Block Height (in Offset Screen top/left) increments oneself.
The same value can i see in Digitizing Wizard "Width X" !
In Digitizing Wizard i can not enter "Width Y" and "Z travel" the values are overwritten onself.
In other respects my machine works very well since years.
Now i will use the Digitizing Wizard with my new XYZ probe.
I use Version R3.042.038
Could everyone help or give me a idea to isolate the problem ?
best regards :)
fridolin
-
Ok ... i found the problem myself. 8)
I have conflicting OEM variables used in the range 1001 to 1009.
My variables monitors the micropump macro and modbus inputs via brains.
Gage Block Height use a OEM Variable 1001 and Digitizing Wizard use OEM variables 1002 to 1007 !
This isue is not documented in the manuals. ::)
best regards
fridolin