Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Venan on September 19, 2014, 05:05:14 PM
-
Hi gys!
It is possible to use two 3 axis usb controlles like this one:
http://www.ebay.com/itm/CNC-USB-Card-3-Axis-MACH3-200KHz-Breakout-Interface-Adapter-/161086021824?&_trksid=p2056016.l4276
to build a 6 axis CNC machine?
Thank you in advance!
-
No, but you can use two parallel ports, or a Smoothstepper.
-
Can i use this one: http://www.cncrouterparts.com/ethernet-smoothstepper-setup-guide-p-286.html for 6 axis machine?
-
Yes
-
After the smootstepper (on port 1-3) what i have to connect - two 3 axis controllers or directly the step drivers?