Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Misfitz2u on September 19, 2014, 03:14:30 PM

Title: HELP...this poor girl is clueless!
Post by: Misfitz2u on September 19, 2014, 03:14:30 PM
Ugh...I need to engrave plastic nameplates and have never used a mini computer controlled 3020T DJ router engraver machine or Mach3 ever!!!!! I am completely clueless   ::)  My boss purchased these products, and unfortunately, is under the impression that this is a "plug and play" process.  No one here in our office can operate this...  Is there a simple way to engrave text with this software or is there other software I am needing to purchase?  Perhaps there is "Mach3 for Dummies".  I have spent the last 3 days at work stressing over this and need serious help. Any advise anyone can spare would be greatly appreciated. All I can say at this point is THANK GOD IT'S FRIDAY!!!!
Title: Re: HELP...this poor girl is clueless!
Post by: Mike Irvin on September 19, 2014, 03:30:52 PM
I can help have you set up the machine as per the instructions
Title: Re: HELP...this poor girl is clueless!
Post by: Misfitz2u on September 19, 2014, 03:43:29 PM
Yes, I did manage to set up the machine and load the software per instructions. But haven't gotten much farther than that. LOL  ;D
Title: Re: HELP...this poor girl is clueless!
Post by: Mike Irvin on September 19, 2014, 03:46:53 PM
i just sent you an email
Mike