Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Lotus Pack on September 19, 2014, 10:15:38 AM
-
Hi
I have the latest versionMach3 ...66 and the Turn module is not working properly on threading. I have seen quite a few posts on this subject and it seesm that an earlier version will resolve this problem. My question is; where can I download an earlier version of Mach3? I have tried the download page and can only see the latest versions listed.
Regards
-
Here you go.
ftp://anonymous:guest@machsupport.com/
-
Ok I tried the ftp link this morning and it failed ::), guess it might be down so I will try later. If in the meantime you could check the sites is up and running I would appreciate it.
Thanks
-
Delete the http:// part from the posted link.
-
Right you are Zasto, my bad.
ftp://anonymous:guest@machsupport.com/ (ftp://anonymous:guest@machsupport.com/)
-
Nope, still can't get to this ftp site!
Can you check it please?
Might be something this end. :(
-
Ok, it works :-)
Thanks