Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: rosco on November 08, 2005, 11:52:48 AM

Title: spindel speed disc
Post by: rosco on November 08, 2005, 11:52:48 AM

How and what do I make a spidel disk out of ror a PWM. I have a PWM sensor from cnc4pc.

Thanks

Matt Holtzclaw

Title: Re: spindel speed disc
Post by: Brian Barker on November 08, 2005, 08:11:09 PM

Matt you can make a disk that uses a Prox or a bit of reflective tape.  The Reflective tape is a good way to go because you have such a small amount of work to do getting it hooked up! The one that I saw used was a Prox and a metal disk. This is a but better because you can put stuff all over the plate or the prox and it will keep working.

Hope that is a little help... If you can tell me more I will see what I can do about getting you more info.
Thank you
Brian