Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: jimcav on September 11, 2014, 06:55:32 PM

Title: newbie
Post by: jimcav on September 11, 2014, 06:55:32 PM
need to under stand a few things I been looking at Mach 2 and 3 software, i think that i need an LPT port on computer? Is the LPT port where the pulse and direction signal come from to drive the stepper driver? can someone please direct me to a good site for beginers.

Jim Cav
Title: Re: newbie
Post by: dude1 on September 11, 2014, 10:20:39 PM
Mach3 forum and youtube
Title: Re: newbie
Post by: Chaoticone on September 12, 2014, 04:18:44 AM
Another great source is http://www.machsupport.com/help-learning/f-a-q/ (http://www.machsupport.com/help-learning/f-a-q/) If you see a question you do not know the answer to just click on it and the answer will be displayed below it.