Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: John W on September 10, 2014, 10:32:49 AM
-
Hi all,
Its been a while since I have been here. I have my mill back in action and I was hoping to get some help on a long standing problem I have had with the Mach3 "Jog ON/OFF" button.
If I use my mouse to pick this button, nothing happens. If I pick it three times in super fast succession it finally turns it on. However, when I go to turn it off I only need one pick of the mouse. I tried the key board on the assumption it was my mouse causing the problem. Unfortunately the same thing occurs. One press of Ctrl+Alt+J does nothing. If I hold Ctrl+Alt down and press J quickly three times on the keyboard, it turns the jog on.
I have searched the forum and found nothing to help me.
I very much hope someone can provide some insight into this nagging problem. It's not life threatening or anything. Its just a real nuisance. :(
Thanks
John W.