Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: 1Acnc on September 07, 2014, 01:59:36 PM
-
When on the Program Run page, my my keyboard short cut keys ( the 4 arrow key and I am using A and Z for Z axes ) work to move the DRO and the motor run. If I go to the Tool Path page they stop working. I can hit the TAB key and the jog screen appears and the mouse can be used to move the motors. If I go to the diagnostics page, the hot keys work fine for moving the motor and DRO. Is this the way it works or do I have something set wrong? The reset button is green. Using a Dell machine, with XP and Mach 3. ???
-
same here .hope to get a reply
-
You cannot jog with the keyboard from a page that does not have the jog enable LED on it.
Brett
-
I looked at the Tool path page, I did not find anyplace to turn on the Jog LED , is that correct? So you are saying that you can not use key board short cut keys on the Tool Path page?
-
You could use one of the screen designers to add the Jog enable LED to that page and it will work.
Hood
-
Thanks to all that replied.
I have been resisting learning about screens, the learning curve for this hobby is steep. CAD, CAM, Mach 3 and G_Code. I just did not want to learn one more thing. I have been reading this forum for some time and kept seeing Screen were the answer to many problems or questions.
I did not know what is was, now I do. I am going to post a little of what I learned.
Again thanks