Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Mike Irvin on September 06, 2014, 10:23:55 PM
-
If you scale down a drawing "mach3" scale do you have to scale down the end mill also.
Mike
-
Yes. ( if you want the contour to be correct without using cutter compensation )
When you use cutter compensation ( G41 ; G42 ) then no, you can use the same endmill.
But the smallest radius in the scaled contour must be greater ( or the same ) as the endmill radius.
This may be a problem when scaling down. A use of a smaller endmill may be necessary
Alex
-
Thanks for the info
Mike Irvin
-
Crap.....I came here looking for a dumb question. That was not dumb at all. It did not un-impress any of us. Try harder, Mike. Your lack of effort is, well....unimpressive. ;D