Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: bitviper on August 22, 2014, 05:07:56 PM
-
Any way I can get mach3 to run a program when it's done milling? I can then make that program email me or something so I don't have to go keep checking on it.
-
Search here. It's possible for Mach3 to email you. There should be instructions here somewhere
-
:)
I did search for "email" and "notify" before posting. Saw a lot of stuff unrelated. Will look some more then.
-
You could clamp a mobile phone on the table set on SMS with a message to you ready to go, then get the mill to stop its spindle, move over to the send button, and gently press it?
;>))
-
its been done seen it on you tube it was NYC CNC
https://www.youtube.com/watch?v=pUre4c79p8I&list=UUe0IyK4ntgdPTTjsxjvyHPg
-
http://www.cnc-arena.com/en/forum/how-can-i-get-email-notification-job-complete--173656.html
-
Also, you might want to contact Terry and see if he can direct you to it.
http://www.machsupport.com/forum/index.php/topic,27120.msg192417.html#msg192417