Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: sharonkayeee on August 17, 2014, 09:35:13 AM

Title: manual cutting
Post by: sharonkayeee on August 17, 2014, 09:35:13 AM

please tell newbie how to cut off drop end of plate on plasma table

Title: Re: manual cutting
Post by: Davek0974 on August 17, 2014, 10:00:13 AM

I have a short gcode file stored, all it does is ref the surface, pierce and a cut a line on one axis only.

When I want to cut-off I just load it up, edit the line length to what ever the plate is, position on the edge and run the cut, takes seconds.

Title: Re: manual cutting
Post by: sharonkayeee on August 18, 2014, 06:55:57 AM

thanks, sharon