Machsupport Forum
Third party software and hardware support forums. => Mach3 and G-Rex => Topic started by: cavery85 on August 09, 2014, 12:39:20 AM
-
Hi fellas,
I am having some trouble with my mach 3. I used to be able to shut down my PC in between tool paths and come back..Turn my PC on... change bit and touch off then run next toolbar and it would be fine... but lately if I do that when I turn PC back on it will be off and ruin the piece im working on . Is there a way to troubleshoot this? Any assistance would be greatly appreciated. Thanks fellas!