Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: dresda on August 07, 2014, 10:46:58 PM

Title: Touch screen help
Post by: dresda on August 07, 2014, 10:46:58 PM

I might of posted this before but do I need to do anything special if I want to use a touch screen. I am thinking of selling my mill and have been using a key board and mouse, but I think if I make it touch screen it might be easier to sell. Will any of the Mach3 screens work with touch screen?
Thanks Ray.

Title: Re: Touch screen help
Post by: BLM on August 08, 2014, 07:35:58 AM

I have a new Dell Inspirion (not sure of model) All-in-one that I run Mach3 on. It works great, although I wish for bigger "buttons" in Mach3 sometimes. Make sure it is "capacitive touch" not laser. Handles dirt better and is easier to control with touch only. Brian