Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: HimyKabibble on August 03, 2014, 10:48:21 PM
-
A friend of mine just bought a CNC router, which has a slaved axis on the gantry. All works perfectly when jogging, but when homing, the two slaved motors move opposite directions. What settings can cause that?
Regards,
Ray L.
-
Home negative in Config>Homing. Make sure both are the same.
If they are the same, then one axis is backwards, and he needs to reverse it.
-
Gerry,
Thanks, I'll have him give that a try.
Regards
Ray L.