Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Werner on March 24, 2007, 11:54:30 PM
-
Can Mach3 be run with Mach2 driver??
Thanks
Werner
-
Hi, Werner
No, but both can co-exist on your computer, Allowing Mach2 and Mach3 to be used.
Hope this Helps, Chip
-
Hi Chip,
Is it no problem to have two drivers in the device manager for Mach2 and Mach3?
Thanks
Werner
-
Hey Werner,
That should be no problem. :)
Brett
-
Cool I will give it a try!!
Thanks Guys
Werner :)
-
Hey Werner, I just read your post again. You can have one driver for Mach 2 and one driver for Mach 3, not two for each. Just makeing sure we are on the same page.
Brett
-
Hi Bret,
I think we are on same page. I had one for Mach2 and one for Mach3. But could not get Mach3 working.
Thanks ???
Werner
-
But could not get Mach3 working.
Could not or have not? Is it working now?
Brett
-
Hi Brett,
Day seven and still no luck!! ??? Please go to the stepper thread and you will see what I have been up to.
Thank Buddy
Werner