Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: mikemill on July 11, 2014, 11:55:10 AM

Title: MachTurnNo2
Post by: mikemill on July 11, 2014, 11:55:10 AM

I have an Orac lathe converted to Mach several years ago, the computer hard drive failed, I have since got a used computer with XP and loaded Mach also the C11.xml file that I had a copy of.
As I have not used the lathe for years, and my memory on how to use it is fuzzy, in manual mode the spindle runs, but I can’t get it to jog, tried with jog on and jog mode on and off.
I think there is something simple I am not doing? I have attached the xml if that helps
Could someone advise please?
Thanks

Mike

Title: Re: MachTurnNo2
Post by: mikemill on July 12, 2014, 09:47:06 AM

Problem solved, computer issue
Thanks
Mike