Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Keith on February 25, 2006, 03:13:52 PM

Title: DRO change
Post by: Keith on February 25, 2006, 03:13:52 PM

Hi,when I go into the diagnostic page of Mach3 to do a little jogging and 'zero' some coordinates,when I retuen to the 'program run' page the settings have changed and I can't get back my coordinates(even if I go back to 'diagnostics'). The number change looks pretty arbitrary.-Keith

Title: Re: DRO change
Post by: Art on February 25, 2006, 03:16:30 PM

What buttons are you pressing on the Diags page. Sme of the code there can be different, its really a page for me to aid in diagnosing problems..

Art

Title: Re: DRO change
Post by: Keith on February 25, 2006, 04:07:48 PM

Oh...well I'm zeroing out there.Isn't that the only page that has the change from 'continuous'/'step' jogging?I suppose I could reach my destination there and go to 'program run' page to 'zero'.I know you can jog on any page that has the on/off jog but that was the only place I could find the change to 'step'...that's the only reason I'm going there.I used to do it on the 'program run' page.

Title: Re: DRO change
Post by: Hood on February 25, 2006, 06:33:35 PM

If you press the Tab key you will get a flyout screen with all the jog settings you require.
Hood