Machsupport Forum
General CNC Chat => Show"N"Tell ( What you have made with your CNC machine.) => Topic started by: dfurlano on March 21, 2007, 09:34:21 PM
-
Well not sure that this goes in show "n" tell but I think it is close...
Thought i would post how I am starting to manage a pen project in Microsoft OneNote which is a notes management software tool.
Here is the main page notice the tabs across the top:
(http://www.dfurlano.com/traveler/Main.jpg)
From the main page I created an index of all the components I wanted to document. So far I have only done the compass.
(http://www.dfurlano.com/traveler/index.jpg)
Next you can go to the compass main page folder now notice the tabs on the right side. These are the steps in the process. I will show each one:
(http://www.dfurlano.com/traveler/compass1.jpg)
Now into the first tab marked set-up:
(http://www.dfurlano.com/traveler/compass2.jpg)
Next is the raw material. I can put a link to the website and I saved the page as a PDF encase the page ever changes.
(http://www.dfurlano.com/traveler/compass3.jpg)
Next is the DXF drawing file. I posted a photo and attached the actual file into the page:
(http://www.dfurlano.com/traveler/compass4.jpg)
G-code is the same style with a picture and the file:
(http://www.dfurlano.com/traveler/compass5.jpg)
Next is the tool I used to make the cut again I pasted the website and this time I did a screen capture of the tool.
(http://www.dfurlano.com/traveler/compass6.jpg)
Next I described how I sharpened the tool. This page is long with many pictures and a step by step method.
(http://www.dfurlano.com/traveler/compass7.jpg)
Next is the machine set-up again this is fairly long but I only captured a page to show it here:
(http://www.dfurlano.com/traveler/compass8.jpg)
This is the bending process:
(http://www.dfurlano.com/traveler/compass9.jpg)
And finally the enameling process:
(http://www.dfurlano.com/traveler/compass10.jpg)
Just thought I would share the idea.
Dan.
-
Thanks for sharing that with us Dan. Art should see this. Have you seen his desk top. ;D
Brett
-
Thanks Dan!
Very informative, and nice to add the resources as well.
Cheers
Lemo
-
You did good :)