Machsupport Forum
Support => Downloads => Post Processors => Topic started by: sdougm on June 05, 2014, 09:20:43 AM
-
Hi Folks!
I like know if any1 have Delcam Solidworks post processor to mach3 or know how I can use the NC files of this app in Mach3.
Thank you
Doug
-
Hi there, I do have several Delcam for Solidworks posts and I can give it to you and every one who needs them. I am just brand new in this forum and do not know how to upload or attach them. I can offer for free: DFS 2013 - mill 3Axis, 4Axis and Turn(turn not tested yet).
-
Sorry man, I inadvertently misguided you. Only post I have for Delcam - mach3 is Turn!!! And it is not tested by me yet!
-
Plese sen me it!
sdougm@gmail.com
Thank you
Doug
-
Hi there, I do have several Delcam for Solidworks posts and I can give it to you and every one who needs them. I am just brand new in this forum and do not know how to upload or attach them. I can offer for free: DFS 2013 - mill 3Axis, 4Axis and Turn(turn not tested yet).
hi, can u send me the post for Mach3 too please¡¡
Alex_ortega6@hotmail.com