Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: rockbaba on June 04, 2014, 10:21:28 AM
-
Hi Every Single One.
I Want To Plasma Cutting machine's with mach 3
I solved everything but ı have to ask 2 questions about mach3 plasma
Question 1
(http://www.sahincnc.com/ENhizalama.gif)
can ı make sheet angle like that with mach3 ?
Question 2
How Can I add Kerf to g codes quickly. is there any plug-in or macros for that.
Thanks For your help.
Best Regards.
-
Do you run a THC an if so what routine code do you run to find the top of material?
-
No I Dont Use THC. I just use Pynomatic System like that. Up and Down (http://i.ytimg.com/vi/ivtzVgO4hJs/0.jpg)
-
OK then you can use the G68 function in mach3 to rotate the toolpath on the sheet.
Just a note on G68 the toolpath will travel the rotated angle BUT mach3 jogs in the unrotated plane.
(;-) TP
-
i know i can make that g68. but everytime i have to calculate that angle. i want to make that. first i find first corner of sheet. then i find another corner of sheet. can mach3 calculate that angle automaticly.
-
It can if you write a script(Mcode) to do it. There is probably a script example somewhere on this site to do it.
(;-) TP
-
really i searched it so much but i couldnt find anything about it. Can you help me where is that script or smilar scripts.
-
how ? No one help me ?
-
straighten the sheet. is that not the simpler solution?a pry bar will move even the largest plate. recently cut a sheet of 2 1/2
plate 10'x5'. 4600 lbs. setup time less than a minute.