Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: greg on March 16, 2007, 09:31:22 PM

Title: advanced motion controllers
Post by: greg on March 16, 2007, 09:31:22 PM

i got some advanced motion controllers in a deal with something i wanted. i have [or believe i heard]that they will not work with mach3. can anyone shed any light on this subject? if they will work is there anything special i need to do to make them work? thanks greg

Title: Re: advanced motion controllers
Post by: ger21 on March 16, 2007, 10:07:38 PM

You might need a step/direction to ±10V conversion board. http://www.skyko.com/products/