Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: bbrown2005 on March 16, 2007, 03:21:04 PM
-
hi,
I am having trouble getting my motors to move when i jog. this is a new set up i am new to the cnc i just caught the bug and had to try it. when i try to get an axis to move my g320 faults and a dir led on the X axis on my g100 glows bright. i can not figure it out any help would be apprecated please. :-[
thankyou
ben
-
hi did you ever get this figured out
I am having trouble also and need some help