Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: comet on March 16, 2007, 03:01:16 PM
-
Hi,
does anyone know or have any expieriance of a post for mastercamx that works
with mach3?
I have used master cam 8 with a turbocnc post for mach but the same post wont work
with mcx niether will the mc9 post on the mach3 website.
Any Ideas?
Tony
-
Run the update post chook on your old posts. That will convert your old posts into version X format and create the machine and control definition files.
-
Fanuc 6 or 11 post is normally ok.
Graham.
-
cheers Guys
did the update on my old post and I'm up and running again.
I shall try the fanuc posts when I have a minute.
Tony
-
Graham,
would you have a fanuc 6 or 11 post I'm having problems with
my post doing wierd things during peck cycles
Tony