Machsupport Forum
Third party software and hardware support forums. => Newfangled Mill Wizard => Topic started by: BR549 on May 11, 2014, 10:46:16 PM
-
HI RON, I noticed the old version had a link to Mach4 and the latest version does not . I still see that the mach4 HOTKEY will open the older version still.
Are you going to be able to use Mill Wizard from inside MACH4 ???
If not there is a solution I have tested and works.
Just a thought, (;-) TP
-
yes, that is the plan. Brain did some work on that a while ago, so when Mach4 is released it should be there.