Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: BR549 on May 07, 2014, 04:00:31 PM
-
OK I have beat up on MAch4 for most of the Gcode stuff that I can without being able to MOVE the machine.
I could suggest a read of a Fanuc and HAAS Gcode manual
AND it is what it is AND what it does have does work well so far (;-) and should be very familar with most folks.
Just remember MACH3 it is NOT in many ways. RTFM
IS there anything NEW ready yet ??
(;-) TP
-
Nope.. we are using all the magic dust we can.. Still takes time to make code that works ;)