Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: craigdlm on May 01, 2014, 07:07:56 AM
-
Can I load and run multiple G-Code files into Mach3? I need to profile a hole then pocket finish it to 19mm but can't see any way to program that in V Carve. I tried 2 different toolpaths, setting the pocket cut with a 5.5mm cutter and then the profile to a 5mm cutter (which is it's size) but post processor I use (Mach2/3 Arcs (mm)) doesn't let me use multiple 'tools'. So I can generate as single G-Code files but I can't see any way to load multiple files?
-
I've just found the wonder of pocket allowance! However, the question still stands about multiple codes!
-
When saving toolpaths, select all of the generated ones and check "Output all visible toolpaths to one file" checkbox.
-
http://support.vectric.com/aspire-questions/item/what-is-pocket-allowance-used-for
-
Use one of the Mach3 ATC posts, and you can output multiple toolpaths with different tools.
-
NO only 1 Gcode program per load. NOW you can stack up serveral files in 1 program BUT you have to delete out any mid file M30,m20,etc as those will stop the file at that point.
(;-) TP