Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: sonnybelew on April 28, 2014, 05:27:27 PM
-
Hi guys. I couldn't find this answer throughout the boards so I hope to get the answer from you here.
I bought a new Syil X5 CNC machine that came with Mach3 ( I was told it is fully licensed). It works perfectly but I continue to have this one problem.
The toolpath window only shows part of the toolpath when it is a larger toolpath. From what I can tell on this forum, this would be a problem with not having a licensed copy and the toolpath only showing 1000 lines of code. How, or where, can I look on the software to find out..??
Thanks for the help
Sonny
-
Help/About ...
-
And it's 500 lines of code, not 1000.
Contact license@machsupport.com to find out if you have a valid license.