Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: mhdale on March 14, 2007, 10:50:52 PM

Title: Driving the Analog out on a CNC4PC IO Board
Post by: mhdale on March 14, 2007, 10:50:52 PM

Hello again, Since I have reduced my settings because of losing position issues I have noticed some issues with the output to my VFD. I am using the CNC4PC Multifuntion board to generate the  0-10V analog signal needed for the spindle drive , but when I set my settings as per the instructions I get perhaps 55% of the output that it says I should with the adjustment trim pot maxed. Is anyone else out there using one of these board and have you had any issues getting the 0-10 Range using the suggested settings?

Mike

Title: Re: Driving the Analog out on a CNC4PC IO Board
Post by: Chaoticone on March 15, 2007, 08:27:53 AM

Hey Mike,
   I have seen other post on this topic. I can't remember exactly where or their name. Might need to do a couple of searches.


Brett