Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: djk on April 17, 2014, 04:05:36 PM

Title: Mach3 wizard problem
Post by: djk on April 17, 2014, 04:05:36 PM

Hi

I had a old Demo mach3, every thing worked well. I updated and brought a license, now I have a problem with the wizards- cut circle - kiran.
First thing, when I have X center and Y center 0 the center is off to the side and the finish pass is off center. Second thing is circle Dia and tool Dia are wrong. I have to change these to circle radius and tool radius to get the right size circle.
If some one can help.

Thanks David

(http://)

Title: Re: Mach3 wizard problem
Post by: Hood on April 17, 2014, 05:27:57 PM

You have the IJ mode set wrong, go to General Config and change it to Inc.
Hood

Title: Re: Mach3 wizard problem
Post by: djk on April 18, 2014, 06:40:06 AM

Thanks Hood everything is working fine now.

David