Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: atwoodr on April 07, 2014, 10:41:25 PM
-
Is there a way to simply have a customizeable keypad pop up in Mach3 that will allow the user to enter a value for a particular DRO on the screen? We are developing something for a tablet and this would be really helpful.
The MachScreen Kaypad only can do this for 1-6 DROs, they cannot be user-defined DROs, and I need between 5-9 on 17 different screens (that is more than 100).
-
The Auto Calculator might work for you. I think it works with all DRO's.
It's a bit tricky in that you have to type a zero before the decimal point for anything less than 1.0000 and you have to hit the +/- button to enter a neg. value. Then hit Enter of course.
It works well once you get used to it.
Russ
:)
-
Is there a way to make that popup bigger or customize the size? The default size has buttons that are too small for a touchpad.
-
There probably is a way but it is above my level.
Would be nice to be able to comfortably use it with a touch screen though.
Good luck to ya,
Russ