Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: scrambled on April 02, 2014, 04:54:37 PM
-
Hi all
I bought a non working Mazak qt 15 lathe. I was told it is a minor problem, but so far it is still broke.
I know it should be fairly easy (not cheap) to switch it over to Mach. I have a Mach flame and plasma now, working on a mill also.
So here is my question-
Do you think it is possible to add "live tooling "to the lathe if I convert it to Mach
Steve
Sent from my iPhone using Tapatalk
-
Yes its possible, not easy but possible, Mach4 will do it much better and with greater ease.